Cable Length |
N/A Up to 4 m |
Dynamic Resolution at 100 Hertz (Hz) Full Scale Output (FSO) |
N/A 0.02 % |
Frequency Response at -3 Decibel (dB) |
N/A 100 Hz |
Linearity Full Scale Output (FSO) |
N/A <±0.2 % |
Temperature Stability |
N/A < 200 ppm/K |
Sensitivity Full Scale Output (FSO) |
N/A <±0.2 % |
Long-Term Stability Full Scale Output (FSO) |
N/A <± 0.04 %/month |
Synchronization |
N/A Yes |
Connection |
N/A 2 x Sockets (Type B) |
Operation Temperature Range |
N/A +10 to +50 ºC |
Storage Temperature Range |
N/A -10 to +65 ºC |
Shock (DIN-EN 60068-2-27) |
N/A 40 g / Half-Sine 6 ms in XYZ Axes / 1000 Shocks Aer Axis |
Vibration (DIN-EN 60068-2-64) |
N/A 10 rms / 10, 500 Hz in XYZ Axes /30 Minutes Per Axis |
Protection Class (DIN-EN 60529) |
N/A Ingress Protection (IP30) |
Number of Measurement Channels |
N/A 2 |
Weight |
N/A 500 g |
Battery Life with 2,500 Milliampere Hour (mAh) Current |
N/A 2 hours |
Control and Display Element |
N/A Touch Display |
Features |
N/A 2 synchronized measurement channels; compatible with all capaNCDT sensors. Storage of measured values on micro SC/SDHC card (not included, max. storage capacity 32 GB). |
Application |
N/A
Rotor gap measurement in the generator The MD6-22 is used for commissioning and maintenance of generators. Inserted into the rotor gap, the flat sensors detect the distance. Alignment of rollers The MD6-22 is used to adjust rollers. Used in commissioning and service tasks, the double-sided flat sensor determines the roller gap. |
Additional Information |
N/A
Mobile gap measurement at the highest precision The capaNCDT MD6-22 gauge is a capacitive dual-channel handheld gauge which is compatible with all capacitive sensors from Micro-Epsilon. This measuring system is used in mobile gap and distance measurements and impresses with high accuracy, versatile application possibilities and intuitive operation. Supported with up to 5h battery life and storage of measurement data on SD card, the MD6-22 is ideally suited to mobile applications in service and maintenance tasks. For example, it is used for rotor gap monitoring in wind turbines and to measure the air gap between the turbine blade and the housing. This handheld measuring instrument offers three different measurement modes: Gap Measurement (single-sided) One or two flat sensors for single-sided gap measurement are used. Gap Measurement (double-sided) One flat sensor for double-sided gap measurement is used. Raw Measurement Two distance sensors are used which can be calculated together. Mobile gap gauge The MD6-22 handheld gauge calculates the sensor signals. It has two connections for two sensors or one dual-channel sensor. The rear magnet enables on-site mounting. Based on intuitive touch operation, all parameters can be set quickly. The measurement values are displayed and can be stored on an SD card. Calibrated system for measurements independent of the alloy The capacitive measuring principle enables measurements on all conductive measurement objects. The sensor and the controller are factory-calibrated and matched to one another. When replacing the sensors, recalibration in the factory is recommended in order to maintain the high measurement accuracy. Up to 5 different characteristic curves can be stored in the handheld gauge. Automatic gap detection Automatic gap detection simplifies parallel alignment of flat sensors for double-sided measurements, while the sensor is rotated around its longitudinal axis. The system recognizes the correct gap width and displays it. |
